Brake Stop

$59.95

Brake Stop.

SKU: 7-0305-00 Category: Tags: ,

Description

There are a number of inexpensive combo shear, brake and roll machines.  They have a rudimentary stop That can be used for the brake, but it is difficult to set and limited in use.  Our Brake Stop fills 3 functions.  It works to square up narrow pieces, sets a back or front stop,  and it provides a down stop to control the angle of bend.

The Brake Stop is sold as one piece.  This is suitable for small parts.  For large parts order 2, 1 for each end.

The stop can be set on the front, back, left or right of the main bar.

To use the stop, at least one of the punch segments must be removed.  The bar will fit a maximum of 20mm (.787″) width dies.  The bar is 1″ wide and if the down stop is in place, approximately 2″ of punch section must be removed to install the brake stop. Place the main bar over the brake die.  Snug up the screw on the front block located on the bottom of the main bar.  Check that the bar is square with the die and then tighten the mount screw with a 5mm Allen wrench.

 

The stop can be set as close as the edge of the female die, and as fas away from the edge of the die as 4.25.

The down stop is adjustable from 4.5″ above the die to 3.875″.  If a lower height is required, you can substitute the 3/8 x 16 x 3.5″ stop bolt supplied with the length required for your application.

Setting the back stop is easy.  Especially if removed from the Brake.  Simply measure from the bottom block which rests on the back edge of the die to the back stop.  Tighten the back stop with a 5mm allen wrench.

download the Instruction sheet here.

Additional information

Weight 1.0 lbs
Dimensions 11 × 3 × 2 in